| |
| |
| |
The V-Tec system can convey product from drums, 20-25kg bags, bulk bags or bag dump hoppers by utilising either a pickup wand or hopper charging adaptor. The conveying air flow can be manually adjusted to allow either lean or dense phase conveying. This minimises product degradation and line wear while maximising system through-put. The conveying cycle is a cyclic process filling the hopper then discharging at preset intervals.
The tangential inlet transition causes a cyclonic effect on the incoming product separating the product and conveyed air. The air then passes through the filter, multistage vacuum pump and out to atmosphere. The hopper exhaust valve opens discharging product into the down stream process below. The system continues until a signal is received closing the supply pneumatic air solenoid valve.
The V-Tec hopper loaders weigh from 10-36kg making them extremely light and transportable. Each unit can be easily dismantled into smaller more manageable sections allowing ease of relocation and cleaning by a single operator. The side mounted quick release clips provide extremely fast access and reassembly to all sections of the V-Tec hopper loader. Silicon seals ensure hygienic sealing between each section.
- V-Tec Multi Stage Vacuum Generator
- Hopper
- Exhaust Valve
- Filter
- Conveying line
- Pickup Wand
- Control Unit
- Air Receiver
|
|
|
|
| |
|
| |
|
|
|
|
